Spectra Precision FAST Survey - Manual (Page 10)

English
2
Installing FAST Survey
This section describes how to install FAST Survey from the
Spectra Precision web site.
FAST Survey can be installed on the following Spectra
Precision data collectors:
• Ranger 3
• T41
• ProMark 100, 120, 200, 220 (ProMark 1x0, ProMark
2x0)
• MM10 data collector
• MobileMapper 6
• MobileMapper CX
• FT-1
If Windows 7 or Windows Vista is used, you don’t normally
need to install an additional program on your computer.
However, if the installation of FAST Survey fails, you will have
first to install Windows Mobile Device Center and then
resume the installation of FAST Survey.
If Windows XP (or older OS version) is used on your computer,
you first need to install Microsoft Active Sync on your office
computer.
The latest versions of ActiveSync and Device Center can be
downloaded from
http://www.microsoft.com/en-us/download/ .
In the procedure described below, the term “data collector”
is used to designate a “pure” data collector (i.e. without
embedded GNSS receptions capabilities) or a GNSS
handheld such as the ProMark 220 or the MM 10 data
collector).
Note that the ProMark 1x0 or ProMark 2x0 may be used:
• Either as standalone RTK equipment using an external
antenna and running FAST Survey (ProMark 220 typical
use).
• or as a simple data collector for other Spectra Precisions
receivers. In this case, the internal GNSS reception
capabilities are not used.
Installation
Procedure
• Download the latest version of FAST Survey to your
computer. This version is available from the Spectra
Precision website:
http://www.spectraprecision.com/products/surveying-
software/fast-survey-downloads.aspx