Spectra Precision FAST Survey - Manual (Page 18)

English
10
Configuration
Steps
In FAST Survey, tap on the Equip tab and then on the GPS Base
button. A message may appear asking you to confirm your
choice of configuring a base. Tap
Yes. This opens the Current
tab of the GPS Base window. You will have to go through four
different configuration tabs (only three for ProMark 220)
before the base is configured and made operational.
Legend used in all the tables below:
“•” (blue background): The parameter exists for the considered GNSS receiver
and needs to be set to some value.
<Blank>: The parameter does NOT exist for the considered receiver.
“NA”
(Non Applicable): The parameter exists but is irrelevant to the
considered receiver.
<Any_Other_Text> (orange background): The parameter exists for the
considered receiver and the text tells you the value you should assign to the
parameter.
Current Tab
Use this tab to identify the GNSS receiver FAST Survey has
to configure as a base.
The button allows you to read the following information
from the receiver:
– Firmware version
– Receiver ID
– Power status
– Free memory space
– Firmware options installed.
FAST Survey will connect to the receiver via the currently set
connection to get this information.
Tap on to return to the Current tab.
Parameters EPOCH 50 ProMark 220 ProMark 800 ProFlex 800
Manufacturer, should
be set to:
“Spectra Precision”
Model, should be set
to:
“Epoch 50”
“ProMark
100/120/200/
220”
“ProMark
800”
“ProFlex
800”
• • • •
Load/Save/Rename/
Delete Configuration
File
• • • •