Spectra Precision FAST Survey - Manual (Page 15)

Engl
ish
7
How FAST Survey Interfaces With a GNSS Receiver Via
Bluetooth
First-Time Use Right after you start FAST Survey and create or open your first
job, FAST Survey will activate the previous connection to the
receiver, if that is possible.
Assuming a base and a rover are nearby and powered on,
follow the procedure below to perform a Bluetooth connection
with the base.
• Tap
Equip>GPS Base.
• On the Current tab, select “Spectra Precision” from the
Manufacturer drop-down list, and choose your model from
the
Model drop-down list.
• Tap on the Comms tab.
• Select “Bluetooth” from the Type drop-down list
and“Windows Mobile” from the Device drop-down list.
• Tap on . This opens the Bluetooth Devices window.
• Tap Find Receiver. Wait until FAST Survey lists the
Bluetooth identifiers of the base and rover. The list
appears in a new window.
• Highlight the Bluetooth identifier corresponding to the
base.
• Tap . This takes you back to the previous screen where
the selected Bluetooth identifier remains highlighted in
the list. The following actions may be performed on the
selected receiver using the following buttons:
• Set Receiver Name: By default, the “Receiver Bluetooth
Identifier” of the detected receiver is assigned to this
parameter. You may use a more self-explanatory name
to identify your base (e.g.: “MyBase”).
• Set Receiver PIN: Do not use this button. In its default
configuration, your equipment does not request a PIN
code to allow a peripheral device to connect to it via
Bluetooth.
• Delete Receiver: Removes the selected receiver from the
list of remote receivers detected by Bluetooth.
• Tap to connect the data collector to the base via
Bluetooth and then configure the base according to your
needs (see Configuring a Base on page 9).
• Later, you will establish a Bluetooth connection with the
rover. The process will start when you tap Equip>GPS Rover