Spectra Precision FAST Survey - Manual (Page 40)

English
32
• Through the Base ID drop-down list displayed further
down on the screen, select the name of the base you
want to work with.
If the Base ID list is blank, tap on next to it. In the
Name drop-down list, overwrite “<New>” with the
name of the base. Then enter its IP address and IP
port.
NOTE: For each new base entry, first select “<New>”
from the
Name drop-down list, and then enter the base
parameters (Name, Address, Port, Send Rover Position
to Network?). Reciprocally, when you want to delete a
base entry, first select its name from the
Name drop-
down list and then tap on the Delete button.
• Tap to validate the new base entry and return to the
RTK tab. The name of that new base is now the current
selection in the
Base ID field.
4. Setting a rover to make a phone call to the base (Direct
Dial):
– Choose the appropriate device so you can set
Network=“Direct Dial”).
– Tap on next to the Base ID field to name the base
and enter its phone number. For EPOCH 50 and
ProMark 700, you additional need to specify the type
of corrections delivered by the base.
End of Rover
Configuration
Phase
• After you’ve been through all the tabs, tap to save all
your settings. The rover will start operating as configured.