Spectra Precision FAST Survey - Manual (Page 11)

Engl
ish
3
Choose the installation file (an “exe” file) corresponding
to the model of data collector you are using.
• Connect the data collector to your office computer using
the USB data cable provided. For a ProMark 1x0 o r
ProMark 2x0, place the receiver on its docking station and
connect the docking station to the computer through the
USB cable.
• Turn on the data collector.
• On your computer, run the “exe” file you have just
downloaded. This starts the FAST Survey Setup Wizard.
• Click Next>.
• Check on the I accept the terms in the License Agreement
option and then click Install.
• At the end of this phase, a message appears asking you to
check the data collector screen to see if additional steps
are needed to complete the installation.
• Click OK, then Finish to complete installation on computer
side.
• On the data collector, the installation phase has
automatically started. For a ProMark 1x0 or ProMark 220,
a message first appears asking you to choose the location
where to install FAST Survey (the default “Device” option
is recommended), then tap on
Install to continue.
When the progress bar disappears from the screen, this
means installation is complete. The FAST Survey icon can
then be seen on the screen.
For a ProMark 1x0 or 2x0, a message indicates that
installation has been successful. Tap
OK to go back to the
screen where the FAST Survey command line and icon are
now visible.