Star Water Systems HSP20P1 - Manual (Page 11)

11
PUMP PREPARATION FOR WELL ANd SURFAcE WATER
PUMP INSTALLATION FOR WELL ANd SURFAcE WATER
1. Mount pump on a solid foundation as close
to the water source as possible.
cAUTION: Support the 2 in. inlet
pipe from the well or lake to the inlet port
to prevent sagging. Sagging will create air
pockets within the pipe that will prevent the
pump from priming and operating correctly.
2. Glue female 2 in. union (not included) to
the end of inlet pipe leading from the water
source.
Water Level Discharge to
Sprinkler System
Well Seal
100 PSI
Pressure
Gauge
Priming Plug
Union
Ball
Valve
Outlet
Pipe
Inlet
Pipe
Well
Union
Water
Level
Outlet Pipe
Inlet
Pipe
2 in.
Female
Union
16. Support inlet pipe with pipe support (not
included).
Pipe
support
Slope pipe upward
from water source
Use a concrete block or
other solid material to
support suction pipe
Water level
16
1
2