Star Water Systems HSP20P1 - Manual (Page 16)

16
A B L2
L1
IL1273
4
PUMP ELEcTRIcAL INSTRUcTIONS
4. Connect white power lead to L1 and black
power lead to L2.
5. Connect green ground wire to green
grounding screw. Re-install rear motor cover
to pump.
To change from 230 V to 115 V
6. The motor of pump is dual voltage and
can run on either 115 volts or 230 volts. In
general, 230 volts is more economical to run,
and requires a smaller wire size. The pump
is pre-set in the factory to run at 230 volts.
A B L2 L1
IL1274
A B
L2 L1
GRAY
RED
5
6