Triton RT2000 Installation Manual - Manual (Page 25)

25
S
ITE
P
REPARATION
/I
NSTALLATION
D
ETERMINE IF
U
NIT NEEDS A
P
LINTH
Triton Systems offers two (2) metal-constructed optional plinths w/leveling feet. A
“plinth” is a platform on which the ATM rests or is secured. A plinth enables the
ATM to be installed at the required height through the wall. The plinths come in 2
heights: 3” (76 mm - shown below) and 6” (152 mm). You can raise the unit by a
fixed amount (3"or 6") and still be able to level the cabinet by using the plinths
leveling feet. Recommendation: When using the leveling feet, do not exceed 3/
4"in adjustment. To determine if you need to order a plinth with your unit, a few
measurements will be needed at the site.
For sites that currently have a wall opening:
Figure 1. Determine height of
opening to inside floor.
1. Measure from the bottom of opening to inside floor (Figure 1).
2. Cabinet dimensions are 28" from bottom of sleeve to base of cabinet
(Figure 2).
3. Subtract the difference to determine if a plinth is needed or what size plinth
to order or build. If difference is less than 3"(for example), you may construct
your own to fit. (Caution: The leveling feet on the cabinet itself should
not be used to raise the unit more than 3/4").
Figure 2. Height of cabinet base to
bottom of sleeve (28").
28"
(711mm)
Cabinet
“footprint”