Triton RT2000 Installation Manual - Manual (Page 33)

33
S
ITE
P
REPARATION
/I
NSTALLATION
Sleeve
11. Adjust the plinth’s leveling feet to ensure the control panel trim is flush against
the exterior wall and the cabinet is level.
12 Mark the anchor holes through the cabinet floor or mark around the plinth
structure using masking tape, pencil, etc. Remove the control panel trim and
slide the unit back inside.
Figure 6. Trim seated on control panel.
Figure 7. Slide unit back flush to wall.
Figure 4. Trim clips.
Figure 5. Control panel slots.
*** Warning ***
When removing/placing the unit on the plinth, be
mindful that the unit is top-heavy. One person should
support the front at all times! Take care not to damage
the front of the sleeve as this has the control panel
electronics and hardware mounted.