Triton RT2000 Installation Manual - Manual (Page 37)

37
S
ITE
P
REPARATION
/I
NSTALLATION
6. Next, connect the power cable to
the LED circuit board as shown in
Figure 8.
7. With 2 persons (inside/outside),
slide the unit back inside until the
control panel trim is flush with the
outside wall (Figure 9).
8. Before securing/anchoring the
cabinet, check to ensure the control
panel trim is flush against the
exterior wall. Minor adjustments
can be made using the cabinet
leveling feet.
9. Secure/anchor the cabinet to the
floor or plinth, if used. Cabinet/trim
installation is complete.
Figure 8. Connect cable to LED
circuit board.
Figure 9. Slide unit back flush to wall.