Triton RT2000 Installation Manual - Manual (Page 32)

32
RT2000 S
ERIES
- S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
7. Slide/move the unit forward
towards the wall opening so the
sleeve protrudes slightly out the
front exterior (Figure 2). This is
needed to temporarily affix the
control panel trim. Minor
adjustments for raising the unit
can be made using the plinths
leveling feet (See “Adjusting
Height of Unit” page 30).
8. Locate the control panel trim
included with the unit accessories
(Figure 3). On the back side are 4
clips (Figure 4) that will align with
4 slots on the sleeve control panel
(Figure 5).
10. Slide the unit back until the trim is
flush against the exterior wall
(Figure 7).
5. If no plinth is needed, slide the unit forward towards the wall opening so
the sleeve protrudes slightly out the front exterior (Figure 2). This is needed
to temporarily affix the control panel trim. Minor adjustments for raising
the unit can be made using the cabinet leveling feet (See “Adjusting Height
of Unit” page 30).
6. If a plinth is used (either built or purchased), mount the cabinet on the plinth.
Anchor the cabinet to the plinth using the bolts provided (optional plinth) or
secure to your built plinth. Tighten bolts enough to secure the two together for
moving the unit.
9. Align the trim bracket clips with
the sleeve slots and insert until the
trim is seated on the control panel
(Figure 6).
Figure 2. Sleeve protrudes slightly.
Figure 3. Control panel trim.