Triton RT2000 Installation Manual User Manual
Page 35
Advertising
35
I
NSTALLING
C
ONTROL
P
ANEL
T
RIM
1.
Locate the control panel trim
included with the unit accessories.
Loosen the three (3) thumbscrews
until the ends are flush with the
bracket. There is a ground wire
attached to the bill tray that will be
connected later (Figure 1).
Trim - front view.
Figure 1. Bill tray.
Trim - rear view.
Thumbscrews
S
ITE
P
REPARATION
/I
NSTALLATION
2.
On the back side of the trim is 4 clips (Figure 2) that will align with 4 slots on
the sleeve control panel (Figure 3).
Ground wire
Figure 2. Trim clips.
Figure 3. Control panel slots.
Advertising