Triton RT2000 Installation Manual User Manual
Page 34
34
RT2000 S
ERIES
- S
ITE
P
REPARATION
AND
I
NSTALLATION
G
UIDE
Adjusting Height/Level of Unit
Triton Systems offers two (2) metal-constructed optional plinths w/leveling
feet. The plinths come in 2 heights: 3” (76 mm) and 6” (152 mm - shown
below).Based on the height requirement needed, you can either:
1) Raise the unit with the leveling feet installed in the cabinet (Business
Hours and Level 1) using a 1/4"(6mm) nut driver/socket.
(Caution: The leveling feet are primarily for that purpose - leveling the
ATM, not to raise the unit by more than 3/4").
2) Construct your own plinth. A “plinth” is a platform on which the ATM
rests or is secured. This plinth enables the ATM to be installed at the re-
quired height through the wall. If built, it must be no smaller than the base
of the cabinet and must be constructed of a material that is capable of sup-
porting the weight of the ATM.
3) Purchase an optional plinth. Raise the unit by a fixed amount (3"or 6")
and, if needed, adjust up using the plinths leveling feet (adjustable crescent
wrench required).
Caution: Leveling feet are primarily used for leveling the ATM, not to raise
the unit by more than 3/4".
4) “Stack” the optional plinths. Before securing two (2) plinths together,
remove the leveling feet from the top plinth.
13. Remove the unit from the plinth (if used). Align the plinth over the markings
and mark the anchor holes. Drill the anchor holes and secure the plinth (if
used) to the floor. Mount the unit back on the plinth (if used) and again slide
the unit forward towards the wall opening until the sleeve protrudes slightly
out the front exterior.
If no plinth was used, after drilling the anchor holes, again slide the unit forward
towards the wall opening until the sleeve protrudes slightly out the front exterior.
The next pages involve installing and securing the control panel trim.
c
c
c
c
c
Leveling feet
d
d
d
d
d
Anchor holes
e
e
e
e
e
Cabinet/Stack holes
c
c
c
c
c
d
d
d
d
d
e
e
e
e
e