AccuMac AM8060 - Manual (Page 31)

AM8060 Precision Thermometer
User’s Guide
30/43
7 Using a Flash Drive （ U disk ） for Data
Acquisition
The flash drive recording start/stop key REC can be used for
saving data to the USB flash drive.
There is a USB port on the rear panel of the AM8060 which
can be used to store the measured temperature data to a flash
drive. Any flash drive with size lower than 4 gigabytes can
be connected to the “UDrive” connector at the rear panel.
The following steps explain how to transfer data from the
AM8060 to a flash drive:
1) Connect a flash drive to the “UDrive” USB port at the
rear panel of the AM8060.
2) When the flash drive is connected, the display will say
“Device Detected” “D:/p” to indicate that the flash
drive is detected. The top left hand corner of the display
should display “UDr” to remind users that a flash drive
is connected and is available for data capturing.
3) If the flash drive is connected while the AM8060 is
turned off, AM8060 will display “Device Detected P2”
during initialization to indicate that the flash drive is
detected, and the upper left hand corner of the display
will show “UDr” to remind users that a flash drive is
connected and available for data capturing.
4) To save the temperature data measured by the AM8060
to the flash drive, just press the REC key on the front
panel. AM8060 will emit a short beep and the LED