Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 - Manual (Page 104)

2.15.4. Menus
[File] menu
Menu command Description of function
New This is used to create new data.
Open This is used to open a file.
Load One-Block This is used to load the data of one block from a file.
Save This is used to save data in the files.
Save As This is used to save the data under a different filename.
Close This is used to close the file.
Properties This is used to display the file properties.
Print This is used to print the displayed data.
Exit DDC Editor This is used to exit the program.
[Edit] menu
Menu command Description of function
Insert-up Block This is used to insert a new block before the current block.
Insert-down Block This is used to insert a new block after the current block.
Delete Block This is used to delete a block.
Copy Block This is used to copy a block.
Move Block This is used to move a block
Change Block Type This is used to change the block type.
[VG] menu
Menu command Description of function
Send to VG This is used to send the DDC data being edited to the monitor.
Receive from VG This is used to receive the DDC data from the monitor.
Verify
This is used to check the DDC data being edited against the data in the
monitor ROM.
[Option] menu
Menu command Description of function
Binary Byte 1 byte
With a binary format display, this is used to delimit the data on a byte
by byte basis, and display the data.
binary Short 2 byte
With a binary format display, this is used to delimit the data every 2
bytes, and display the data.
Binary Long 4 byte
With a binary format display, this is used to delimit the data every 4
bytes, and display the data.
DDC2B This is used to communicate using DDC2B.
DDC1 This is used to communicate using DDC1.
96