Astro Design PORTABLE SIGNAL GENERATOR PROGRAMMING SOFTWARE SP-8848 User Manual
Page 35
Chapter 2 Operation
27
DOTS: Dot pattern
This button is used to set the dot pattern.
The dot pattern is always displayed after the screen center has been calculated. The screen center can be calculated
when the number of display dots and number of display lines are odd numbers. However, when they are even numbers,
the actual screen center will be one dot to the right and one line below the center. An error results when 0 is set for both
H and V.
Mode
Specification as a number of lines (line) or dot intervals (dot) is selected here
as the mode setting.
Format
The save start point (From Center or From Top Left) is selected here.
Interval
The number of lines (when "line" has been selected) or the dot interval (when
"dot" has been selected) of the dot pattern is set here.
Dot size
The dot size is set here.
Dot type
The type of dots is set here.