KYORITSU 1052 - Manual (Page 19)

18
4.3.3 Measurements with SENSOR (SENSOR)
1) Turn the function switch to the “ mV ” position.
2) Get the instrument in the DC SENSOR mode with the SHIFT + SELECT
Keys. Press of the SELECT Key again to use AC SENSOR.
Input voltage will be displayed on the sub-display, and values and units
set according to “input, display and unit settings of SENSOR mode”
mentioned at clause 4.6 will be displayed on the main display.
SENSOR
DC SENSOR Range AC SENSOR Range
3) Connect the SENSOR to the input terminal.
4) Read the value when it stabilizes.
Press the SHIFT + SELECT Keys to return to normal mV measurement.
4.3.4 Resistance Measurement (Ω)
CAUTION
To avoid damage to instrument
Turn off the power to the circuit under test before starting measurement in order to prevent any
excessive voltage from being applied to the instrument.
1) Turn the function switch to the “
Ω ” position.
2) Plug the test leads into the input terminals.
3) Connect the test leads to the circuit under test and then read the value
when it stabilizes. Test leads
Red Black
Note
Zero adjustment
Zero adjustment is recommended for correct measurement. After executing 1), 2) above,
short the two test leads. Press the REL key for adjust. (The display shows the “0.0Ω”
value.) The value (zero adjustment) stores till turn off.