KYORITSU 1052 - Manual (Page 30)

29
Note
Additional functions simply set when POWER ON can be used.
<To enable the AUTO POWER OFF function once again>
1) Turn the function switch to the OFF.
2) Turn the function switch to the desired position of any measurement mode (function).
The AUTO POWER OFF function is enabled again.
The display shows the “ AUTO OFF ” indication.
4.6 Set-up Function
The following settings can be made using the Set-up function:
• default setting of detection method during AC voltage measurement (KEW1052 only)
• default setting of LOGGING interval (KEW1052 only)
• sound on/off setting (beep of buzzer)
• input, display and unit settings of SENSOR mode
• reset to factory preset mode
1) Press the SHIFT key shows “Shift” on the display.
2) Press the LIGHT key changes the mode to Set-up mode,
from Set-up to AC detection method (KEW1052), beep on/off of buzzer (KEW1051).
KEW1052 KEW1051
3) Press the LIGHT key or SHIFT key changes the setting items accordingly.
4) Change values by using the ▲ (RANGE) key or ▼ (REL) key.
5) Press the HOLD key to save/finish each setting.
“SEt” appears and the display returns to the setting items.
6) Hold down the LIGHT key for more than one second to return from Set-up mode to
measurement mode.
Note
To cancel any setting, hold down the LIGHT key for more than one second, or turn off by
using the function switch.
<Default setting of detection method during AC voltage measurement> (KEW1052 only)
Set a default setting of detection methods during AC voltage measurement.
RMS or MEAN: The default setting is RMS.