KYORITSU 1052 - Manual (Page 27)

26
4.4 Memory Function (KEW1052 only)
<To save a Data in internal memory>
The instrument can save a data using with the following two types of modes.
SAVE-mode: Saves a data for one measurement by manual operation.
LOGGING-mode: Automatically saves a data from the start of logging.
Memory capacity
SAVE-mode: 100 data
LOGGING-mode: Logging data of one time 1,600data
Number of saved data
Number of saved data is 4-digit numbers. The instrument allocates the smallest
number, between 0000 to 1599, that has not yet been used. Use the
 (RANGE) key
or

(REL /%) key switches the number of saved data.
To save a Data (SAVE-mode)
1) Press the MEMORY key. (The display shows the “ MEM ”symbol.)
2) Press the SAVE (HOLD) key.
(The sub-display shows the number of saved data.)
3) Press the SAVE (HOLD) key to save the data.
Another press of the SAVE (HOLD) key saves a data for the second time measurement or
later.
4) To cancel the function, hold down the MEMORY key for one second.
(“ MEM ” symbol disappears.)
Note
HOLD data can be saved.
Hold the display and save it according to the above steps.
The number of saved data