KYORITSU 1052 - Manual (Page 4)

3
W ARNIN G
n Always observe the following instructions. Failure to do so may result in
electrical shock or other dangers that may lead to serious injury or the loss of
life.
Test leads / Test leads with crocodile clip (optional accessory)
• Use the probes supplied by KYORITSU with this instrument.
• Do not use test leads/test leads with crocodile clip that have deteriorated or are defective.
Check test leads/test leads with crocodile clip continuity.
• Disconnect test leads/test leads with crocodile clip from the circuit under test before opening
the casing to replace the batteries or for any other reason.
• Disconnect test leads/test leads with crocodile clip from the circuit under test before
attaching/detaching the test leads/test leads with crocodile clip to/from the instrument.
• Disconnect test leads/test leads with crocodile clip from the instrument before opening the
casing to replace the batteries or for any other reason.
• A cap is provided on the tip of a test lead.
Use a test lead with the cap on for safety (safety standards: IEC 61010-031).
• Do not use the crocodile clip of test leads being loosen or removed conditions.
Casing
• Do not use the instrument if there is any damage to the casing or when the casing is
removed.
Fuses
• Use fuses of the specified rating when the fuse is replaced.
Operating Environment
• Do not operate the instrument in an atmosphere where any flammable or explosive gas is
present.
• Avoid using the instrument if it has been exposed to rain or moisture or if your hands are
wet.
Disassembly
• No person, except personnel from KYORITSU, is authorized to disassemble this instrument.