KYORITSU 1052 - Manual (Page 29)

28
• To overwrite selected data
1) Press the MEMORY key.
(The display shows the “ MEM ”symbol.)
2) Press the SAVE (HOLD) key.
(The sub-display shows the number of saved data.)
3) Use the
 (RANGE) key or 
(REL /%) key to select the number of saved data.
4) Press the SAVE (HOLD) key to save (over write) the data.
5) To cancel the function, hold down the MEMORY key for one second.
(“MEM” symbol disappears.)
Delete method (LOGGING-mode)
• To delete all data
1) Press the MEMORY key.
(The display shows the “ MEM ”symbol.)
2) Hold down the LOG (MIN/MAX) key for one second.
(The display shows the “ CLr ? ”symbol.)
3) Press the LOG (MIN/MAX) key.
All data is deleted.
MIN/MAX
LOG
4.5 AUTO POWER OFF Function
<To use the AUTO POWER OFF function>
The display shows the “ AUTO OFF ”indication.
• The instrument automatically turns off twenty minutes after the last key operation.
The instrument will beep for approximately 30 seconds to alert the operator before the
AUTO POWER OFF function takes effect.
• Pressing any key or switch while the instrument is beeping postpones the power-off time.
• Pressing any key once after the power to the instrument is automatically turned off switches
the instrument on again.
<To cancel the AUTO POWER OFF function>
1) Turn the function switch to the OFF.
2) With pressing the HOLD key, turn the function switch to the desired position of any
measurement mode (function).
The “ AUTO OFF ” indication turns off when the function is canceled.