Revo NVR User Manual
Page 15
Part 1 – Introduction
15
Factory Reset
Located next to the Audio Out port on the rear of the
NVR is a switch that, once activated, will reset the
NVR to all its initial factory settings.
A factory reset will clear all NVR settings configured
by the user.
You will need a straightened paper clip to access the
factory reset button.
1
Restart the NVR (turn off and then on).
2
Once the front panel LEDs start to flash, insert
a straightened paper clip into the factory reset
switch hole and press the switch.
3
Press and hold until you hear 2 beeps from the
NVR's internal buzzer.
4
All NVR settings will be returned to their factory
values once you remove the paper clip.
Connections on the Rear Panel
Direc
tIP™ S
wit
ch
Speaker
VGA Monitor
HDMI Monitor
Sensor
Gigabit PoE
Switch
Keyboard
Power (12V)
Power (48V)
Alarm
POS
REVO Remote
Pro Remote
Monitoring
Camera
Camera
Network