Revo NVR - Manual (Page 47)

Part 3 - Configuration
47
• In order to use the Callback feature, the NVR must
be registered on the remote program.
• Select Panic Record to specify which alarm-in
channels to use. Panic Record commences when
the corresponding alarm-in occurs and terminates
when the alarm-in is deactivated.
Video Loss
• Actions: Specify which actions to take when a
Video Loss event occurs.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to
Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
Audio Detection
• No.: Select which cameras to apply Audio Detection
to.
• Sensitivity: Set to between 1 (Low) and 5 (High).
• Activation Time: Specify how long audio detection
has to last in order for it to be considered an event.
Audio detections that do not last for the specified
duration of time will not be considered as events.
• Actions: Specify which actions to take when audio
detection events occur.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.
• Ignoring Interval: The system does not produce
event log entries or issues remote notifications
regarding audio detected during the specified time
following the initial audio detection. Set a value
between 1 sec and 5 secs or choose
Never.
• Use Ignoring Time: Select Time Setup to specify
the audio detection ignore time. Audio detection will
be disabled during the specified time frame.