Revo NVR - Manual (Page 44)

Part 3 - Configuration
44
Motion
• No.: Select which cameras to apply Motion
Detection to.
• Sensitivity: Set daytime and nighttime sensitivity
settings between 1 (Low) and 5 (High).
• Zone: Define the motion detection block.
Use the remote control's arrow buttons to move the
block selection window up, down, left, and right. The
selection window consists of 8 blocks per row. Select/
deselect individual blocks using the
Camera buttons.
You can use the mouse to drag the zone and then
select, clear, or reverse the selection.
From the zone selection screen, press the
button
on the remote control or right-click on the mouse to
open up the Zone Setup menu.
- Select: Confirm the block selection in the
selection window.
- Clear: Clear the block selection in the selection
window.
- Reverse: Clear the blocks selected within the
selection window and select all unselected blocks
within the selection window.
- Select All: Select all blocks.
- Clear All: Clear all block selections.
- Reverse All: Clear all selected blocks within the
screen and select all unselected blocks within the
screen.
- OK: Save the changes and exit the menu.
- Cancel: Exit the menu without saving the
changes.
• Min. Blocks: Motion needs to be detected in more
than the specified number of blocks in order to
trigger a Motion Detection event. You may select a
value between 1 and the number of blocks selected
under
Zone for daytime and nighttime, each.
• Actions: Specify which actions to take when
motion is detected.
- Record: Specify which cameras to begin linked
recording on when an event occurs. If the
schedule is set to Event or Time & Event mode,
the selected cameras will begin linked recording
when an event occurs.
- Alarm-Out: Designate event-triggered alarm-out
channels and beeps.
- Notify: Configure to be notified of events by
Mail, LAN1 through 5, SNS, Push, and/or Alert
Window.
- PTZ: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback feature, the NVR must
be registered on the remote program.