Revo NVR - Manual (Page 40)

Part 3 - Configuration
40
Monitoring Options
System
Define monitoring times. If self-diagnosis is not performed on a regular basis, the
system will assume an error.
Bootup, Restart,
Shutdown Define bootup, restart and shutdown actions.
Panic Record Define panic recording actions.
Check Recording
The system will assume an error if the system has been scheduled to record normally
but recording does not take place during scheduled intervals.
Select Schedule On and then configure the days of the week, times, and monitoring
interval. Select the button on the bottom left of the screen to add a schedule. Select
to delete the schedule.
Check Alarm-In
The system will assume an error if the alarm-in status does not change during the
specified monitoring interval while alarm-in is active.
Disk Almost Full Generates an event if the disk reaches the specified capacity (80% to 99%).
Disk Full Generates an event when all disks reach their maximum capacity.
Disk Bad
Generates an event when the specified percentage of the disk becomes damaged.
Set to between 10% and 90% in 10% intervals.
Disk Temperature
Specify the threshold temperature. Once any disk reaches this threshold, the system
will issue an alert.
Disk S.M.A.R.T. Monitors disks that support S.M.A.R.T. and notifies the user if a disk error is detected.
Fan Error Notifies the user when the fan inside the system malfunctions.
Disk Config Change
It will be highlighted when the NVR reboots after the hard disk drive has been
replaced.
• For system events, only an e-mail notification of actions can be selected.
• In order to use the Notify(Callback) feature, the NVR must be registered to the remote program on the receiving PC's
end.