Revo NVR - Manual (Page 41)

Part 3 - Configuration
41
Record Setup
Refer to the Menu Use on page 34 for basic
information on using the Setup menus.
General
Configure general recording settings.
• Recycle: When the recording disks become full,
the system overwrites existing data with new data,
starting with the oldest first. If
Recycle is disabled,
recording will simply stop when the recording disks
reach their maximum capacity.
• Event Record Dwell: If linked recording is
designated as an event-triggered action, recording
takes place for the duration specified under this
setting. Select between 5 secs and 15 mins.
• Auto Deletion: Configure this option to delete
recording data automatically after the specified
number of days has elapsed. Select between 1 day
and 999 days.
To disable Auto Deletion, select Never. If enabled,
recording data will be stored on the NVR for
the specified number of days and then deleted
automatically. Expired recording data are deleted
automatically at midnight and will be deleted even if
the system reboots or the
Auto Deletion setting has
been changed.
• Limit Time-Lapse Recording: You can store
event recording data for longer. The limit can be
set as between 1 day and 99 days. If you do not
wish to use
Limit Time-Lapse Recording, select
Never. This function is activated when data has
been stored for longer than as configured because
the recording disk has sufficient capacity and saves
new data by overwriting
Time Lapse Recording
data that are older than as specified under Recycle
mode.
• If the recording stored on the disk is shorter than
the duration specified under Limit Time-Lapse
Recording, the older of Event Recording or
Time Recording data is deleted first.
• The system's recording time may change
depending on recording quality, resolution,
motion, and other configurations made by the
user. The duration specified under
Limit Time-
Lapse Recording may not be guaranteed in
certain situations.
• Recording Failover Service: If the network goes
down, this feature will transfer temporary data
stored in the camera's buffer to the NVR when the
network goes online again.
• Record Audio: The camera will record audio along
with video.
• Use Panic Recording: Enable/disable Panic
Recording.
• Panic Recording Duration: Disable Panic
Recording automatically. Select between 5 mins
and 1 hr. If you do not wish to disable the feature
automatically, select
No Limit.
• Video Profile: Select a recording profile value for
Panic Recording.