SUOMY City Tour - Manual (Page 20)

«D-RING» RETENTION SYSTEM see figure 2
The system can change according to the countries in which the helmet is marketed in relation to the particular certification standards.
Insert the free end of the strap in the rings.
Pull until the strap fits tightly around the jaw.
After doing this, it should be impossible to slide out the helmet; verify that, by taking it from the back edge and rotating it towards the front, the
helmet cannot be removed and that it remains well fixed on your head.
If the helmet tends to come off or it moves freely on the head, pull the strap tight until the right pressure is reached and repeat test.
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
Only after the strap has been adjusted tightly, fix the end part of the strap by fastening it with the press-stud on the tongue. (see figure 2).
The only function of the press-stud fitted on the chinstrap is to avoid fluttering of the end part while riding. The fact the press-stud
is fastened is no guarantee that the helmet has been positioned and closed correctly: the correct fastening of the strap must be
verified exclusively through the operations described in the previous paragraphs.
To release the retention system, unfasten the press-stud and pull the tongue to loosen the closure. Slide out the end part of the strap from the
«D Rings».
Use the unlocking tongue only to remove the helmet! Never unlock while riding.
If the retention system does not work correctly, do not use the helmet.
Eng USER’S INSTRUCTIONS
figure 2 figure 3
18
C
A
E
B
A
E
B
D