SUOMY City Tour - Manual (Page 22)

Eng USER’S INSTRUCTIONS
PADDING
The inner padding can be easily removed to be washed or replaced.
Inner central padding: INNER SHELL – Assembly and disassembly – see figure 5
The inner shell is fixed to the helmet through 4 press-studs. (A).
Removing the shell:Snap open the press-studs (A) and remove the inner shell.
Attention: to avoid damaging the inner lining, before removing the inner shell make sure all the press-studs have been snapped open.
Fitting the shell: Insert the shell inside the helmet, being sure to check the assembly direction (A). Fasten the press-studs. After fitting the shell
make sure it fits correctly inside the helmet (polystyrene padding).
Inner side padding: CHEEK PADS – Assembly and disassembly – see figure 6
The cheek pads are fixed to the helmet through two straps that click into the inside polystyrene padding.
Removing the pads: Grab the pads on the bottom end and pull downward.
Fitting the pads: Insert the cheek pad so that the two dented flaps (A) are inserted in the relevant seats (B) positioned in the padding inside
the polystyrene; push the cheek pad firmly against the polystyrene padding until the cheek pad fits perfectly with the lining of the padding inside
the polystyrene.
20
A
A A
A A
figure 5
A
A
B
B
figure 6