Help command), Cc (clear calibration data) – PNI TCM 2.6 User Manual
Page 27
PNI Sensor Corporation
DOC#1009269 r11
TCM2.5 & TCM2.6 User Manual
Page 27 of 49
Related Commands
et= (Enable Temperature)
ut= (Set Temperature Units)
Action Commands
?
(Help Command)
Description
All TCM2.5/2.6 commands are displayed using the “?” command.
cc
(Clear Calibration Data)
Description
Erases all calibration data. Any further magnetometer or compass output is not
corrected for any local fields. This command is only valid during Standby Mode (h).
Use this command before recalibrating the TCM2.5/2.6 for a new or changed local
magnetic environment.
Syntax
cc<cr>
Output
HnVnMn.nn<cr><lf>
Example
cc<cr>
H0V0M0.00<cr><lf>
Query Response
lc? (Last Calibration Score)
Related Commands
mpcal= (Multipoint Calibration)
c? (Compass Update)