Avaya TransTalk MDW 9040 User Manual
Page 15
Important Safety Instructions
Installing the MDW 9040 Pocket Phone System
2
MDW Wireless Pocket Phone Installation and Use, 503-801-190
Issue 2, February 2001
7
•
This product should be serviced by a qualified service center when service or
repair work is required. Do not open the product or push objects through housing
slots. There are no user-serviceable components inside.
•
Use only the type of battery pack shipped with this product or sold as an optional
part. (See
Ordering Replacement and Optional Parts
.”)
WARNING:
!
Do not burn or puncture the battery pack. As with other batteries of this
type, burning or puncturing could release toxic material, which could
cause injury. Do not dispose of the battery pack in household garbage.
For information about recycling or proper disposal, consult your local
solid waste (garbage) collection or disposal organization.
Additional Safety Instructions for Installation Personnel
•
Install the product to meet all environmental and electrical requirements listed in
•
All wiring that connects to this equipment and becomes part of the building
wiring must be a minimum of CLASS 2 or UL (Underwriters Laboratories)
Listed Communications cable.
•
Do not install telephone wiring during a lightning storm.
•
Do not install telephone jacks in a wet location unless the jack is specifically
designed for wet locations. Never touch telephone wires or terminals that are not
insulated unless the telephone line has been disconnected at the network interface.
•
Install this product in a protected location where no one can step on or trip over
power cords and telephone line cords. Do not place objects on the cords that may
cause damage or abrasion.
•
Use only the power supply (Comcode 408082204) shipped with this product for
the battery charger.
•
When required, use only the auxiliary power supply (Comcode 108212952) or the
power supply with battery holdover (Comcode 108212960) specified for use with
this product.