Avaya TransTalk MDW 9040 - Manual (Page 79)

Carrying Your Pocket Phone Programming & Using the MDW 9040 Pocket Phone
5
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190 Issue 2, February 2001 71
Carrying Your Pocket Phone
The MDW 9040 Pocket Phone has a loop in the upper corner to accommodate the included lanyard. You can
attach the lanyard, as illustrated below, and slip the lanyard over your wrist to guard against dropping the phone.
A leather carrying case is also available separately; see
Appendix D , “ Ordering Replacement and Optional
Parts .”
Figure 26. Attaching the Lanyard Loop to the Handset
Each battery pack (standard or extended) also comes with its own detachable clip that
you can attach to the back of the battery pack, enabling you to attach the phone to
your belt or purse strap. Be sure to use the clip that matches the battery pack; they are
not interchangeable.
Fastening the Belt Clip To fasten the belt clip to the handset (or battery pack), refer to the following figure
and set of instructions.
Figure 27. Fastening the Belt Clip
Lanyard Loop
^ and v Volume Control Buttons
< >
(...then push
Belt Clip
Back of WT
Battery Pack
(outside)
(Latch...)
and snap)