Avaya TransTalk MDW 9040 User Manual
Page 80
5
Programming & Using the MDW 9040 Pocket Phone
Carrying Your Pocket Phone
MDW 9040 Wireless Pocket Phone Installation and Use, 503-801-190
72
Issue 2, February 2001
1
Hold the handset (or battery pack) so that the back of the handset (or battery pack)
is facing you.
2
Hold the belt clip so that it looks like the letter “T.”
3
Latch the right edge of the belt clip into the corresponding groove on the inner
side of the battery pack. (The groove is about 1/4 inch from the top of the battery
pack.)
4
Push the left edge of the belt clip and snap it into the corresponding groove on the
inner side of the battery pack.
Removing the Belt Clip
To remove the belt clip from the battery pack, refer to the following figure and set of
instructions.
Figure 28. Removing the Belt Clip
1
Remove the battery pack from the handset.
2
Hold the battery pack so that the inside of the pack is facing you.
3
Find the “larger” edge of the belt clip that is fastened to the battery pack.
4
Push the “larger” edge of the belt clip out and away from the battery pack until
you free the clip from the pack.
Belt Clip
“Larger” Edge
Belt Clip Edge
(Push out to detach)
Battery Pack
(inside)