Brother FAX 1920CN - Manual (Page 98)

SETUP SEND 6 - 9
Color fax transmission
Your machine can send a color fax to machines that support this
feature.
However, color faxes cannot be stored in the memory, so Delayed
fax and Polling Transmit features are not available.
1
If it is not illuminated in green, press ( Fax ).
2
Load your original. (See Load originals on page 2-1.)
3
Enter the fax number using the dial pad, One-Touch,
Speed-Dial or Search.
4
Press Color Start .
Dual Access (Not available for color faxes)
You can dial a number, and begin scanning the fax into memory—
even when the machine is sending from memory or receiving faxes.
The LCD shows the new job number and available memory.
When you send a color fax, the machine will send it in real time
(even if
Real Time TX is set to Off ).
Your machine normally uses Dual Access. However, to send a
color fax, the machine will send the original in real time (even if
Real Time TX is Off ).
The number of pages you can scan into the memory will vary
depending on the data that is printed on them.
If you get a Out of Memory message while scanning the first
page of a fax, press Stop/Exit to cancel scanning. If you get a
Out of Memory message while scanning a subsequent page,
you can press Black Start to send the pages scanned so far,
or press Stop/Exit to cancel the operation.