Axis Communications Axis Network Scan Server 700 - Manual (Page 72)

AXIS 700 User’s Manual Appendix A: Troubleshooting 71
FTP Follow these steps to restore the default settings using FTP:
1. Log in to the AXIS 700 with the command
ftp <IP address> ,
where
<IP address>
is the name or IP address assigned to your
AXIS 700.
2. You will be prompted for user id and password. Use the user id root ,
which has the default password pass ( root is the user id with the
highest priority).
3. Issue the command get defaults to restore the default settings.
The unit will then automatically restart.
4. Log out using the command quit , bye or exit depending on your
FTP version.
The AXIS 700 will now restart with the factory default settings.
Front Panel Indicator Conditions
The Power LED is hardware controlled and should always remain on
when power is connected to the AXIS 700. The remaining LEDs are
all software controlled.
Normal Conditions This table shows the front panel indicators during normal conditions:
Event
Status
LED
Busy
LED
Network
LED
Remarks
Power up On On On Initial power to unit
On Off Off Memory test
Flash Off Off Self test in progress
Off Off Flash
Network LED flashes when
network traffic is present
Scanning Off On Flash
Idle Off Off Flash
Network LED flashes when
network traffic is present
Flash loading Off Blink Blink
During Flash loading, the
Network LED blinks quickly