Appendix c the parameter list, Appendix c, The parameter list – Axis Communications Axis Network Scan Server 700 User Manual
Page 84: Axis 700, User’s manual appendix c: the parameter list
AXIS 700
User’s Manual
Appendix C: The Parameter List
83
Appendix C
The Parameter List
This table shows the AXIS 700 parameter list. The middle column
shows the default values, when applicable. The right-hand column
gives a brief description of the parameter.
Important:
o The parameters are case-dependent. They must be entered exactly
as in the table below.
Parameter name
Value
Description
[Server]
HardwareAddress
= 00:40:8c:18:02:3c
Specifies the AXIS 700 hardware address. The default
setting is the serial number.
Date
= yy-mm-dd
Time
= hh:mm:ss
FactoryDefaults
= no
Set this parameter to yes to reset to factory default
settings. Note that all current settings will be lost.
Restart
= no
Set this parameter to yes to restart the AXIS 700.
TimeZone =
UTC
Specifies the time zone in which AXIS 700 operates.
TimeSyncSource
= None
Specifies the time source for the AXIS 700. Valid values
are NTP or None.
ServerPassword
= pass
Specifies the Server password. The
Supervisor/Administrator will be prompted for this
password when trying to access the AXIS 700 for
administration tasks. The password is used in basically all
protocols, i.e. HTTP, SNMP and FTP. Once written to
the configuration file, the password will be replaced by
*’s, representing each letter of the password.
DefaultProfile
= Text
Specifies the default profile.
DefaultPaperSize
= letter
Specifies the default paper size.
TemporaryDestinations
= yes
Specifies if users are allowed to add temporary e-mail
destinations.
TemporaryProfiles
= yes
Specifies if users are allowed to add temporary scanning
profiles.
WebScanning
= yes
Specifies if users are allowed to use the Scan Document
facility. Scan Document means that the user places a
document in the scanning device, and then displays or
saves the image via the AXIS 700 Web browser
interface.
SpecifySender
= no
Specifies if users are allowed to specify the sender when
scanning from the AXIS 700 control panel.
Front Panel
Configuration
= yes
PDFRotation
= yes
Enables that all pages are in upright position when
scanned double sided.