Canon DP-V3010 - Manual (Page 21)

21 Installation/Connection
Mounting the Main Unit on a Stand or Wall
This main unit can be fitted to a stand* or to a wall mount bracket*.
Screws compatible with this main unit are M6 x 10 mm (VESA Standard 200 x 200 mm).
* Commercially available.
CAUTION
• Make sure to perform this step, with at least two people.
• When mounting the main unit on a wall, make sure the wall has sufficient strength. If necessary, apply reinforcement. Also,
make sure to check the load capacity of the stand or wall mount bracket.
• Make sure that the main unit does not fall during installation/removal.
1. Remove four screws at the rear of the main unit using the supplied hex key HK-01.
Do not lose the removed screw. Do not use these screws for other purposes.
Screws
2. Mount the main unit on a stand or wall mount bracket.
COP
Y