Canon DP-V3010 - Manual (Page 72)

72 Error Messages
Message Description and Action
Operation Invalid operation. F buttons will not function in the following cases:
• When the following function is set during
DisplayPort signal selection:
- H Delay/V Delay
- Time Code
• When the following function is set while "Input
Configuration" is not performed for the selected
channel:
- Aspect Marker
- Safety Zone Marker
- Time Code
• When the following function is set while "H
Delay"/"V Delay" is set:
- Screen Scaling
- Aspect Marker
- Safety Zone Marker
• When the following function is set while "Test
Pattern" is set:
- Aspect Marker
- Safety Zone Marker
- Time Code
• When the following function is set while there is no
signal or there is unsupported signal:
- Aspect Marker
- Safety Zone Marker
"Protect Settings" is on. To use the OSD menu, move the selection frame
to "Protect Settings" and press the SET button for
approximately 3 seconds.
"CDL Override" is on. When "CDL Override" is turned "On", you cannot
adjust the "POWER", "SATURATION", "OFFSET", or
"SLOPE".
"Knob Lock" is on. If the knobs are not functioning, please set "Knob
Lock" to "OFF".
USB memory USB memory is not connected. Correctly connect the USB memory to the USB port
of this main unit.
Unsupported USB memory. Check the USB memory format and make sure it is
not protected.
COP
Y