Andrew 3.7-Meter Earth Station Antenna User Manual
Page 11
For MPJK Types
Only
Main Reflector
Assembly
Mount azimuth pivot assembly to ground mount assembly
Bolt one jack to azimuth pivot assembly
Unscrew jack
Tighten galvanized hardware using A-325 tensioning procedure
Lubricate jackscrews
Pull protective boot over jackscrew
Bolt elevation pivot assembly brackets to ground mount assembly
Bolt second jack to elevation pivot assembly
Unscrew jack
Tighten galvanized hardware using A-325 tensioning procedure
Lubricate jackscrews
Pull boot over jackscrew
Remove protective covering from crate
Pry top crate panel off
Pry sides off crate
Pry front off crate
Unbolt reflector halves from bottom of crate
Prepare assembly area with blocks of wood to assemble reflector
Lay reflector halves on prepared assembly area
Align reflector halves
Insert all hardware as outlined in Installation Procedures
11
Getting Started