Andrew 3.7-Meter Earth Station Antenna - Manual (Page 18)

Step 5
Step 6
Step 7
18
Attach the ground mount assembly to the eight corresponding anchor bolts using a 3/4
inch flat washer and 2-3/4 inch hex nuts as shown in Figure 3-4a. One 3/4 inch hex nut
is supplied with the anchor bolt kit and the second 3/4 inch hex nut is supplied with the
antenna.
Installation Procedures
Figure 3-4a: Ground Mount Assembly Base Hardware
Remove the steel strapping from the ground mount assembly.
Tighten the foundation hardware using the A-325 tensioning procedure.
Figure 3-4b shows the ground mount assembly attached to the foundation.
Figure 3-4b: Ground Mount Assembly Base Hardware