Andrew 3.7-Meter Earth Station Antenna - Manual (Page 30)

Step 10
Step 11
30
Installation Procedures
Figure 3-19: Elevation Strut Pick Up Assembly (Top View)
Bolt the elevation bracket-support plates (P/N 205873) to the elevation strut tube assem-
bly using 5/8 inch hardware (hex bolt, flatwasher and nut)as shown in Figure 3-20.
Figure 3-20: Bracket-Support Plates (Top View)
The next step is to install the elevation strut assembly. Begin by bolting the elevation strut
tube assembly (P/N 205872) to the ground mount assembly as shown in Figure 3-19.