Andrew 3.7-Meter Earth Station Antenna - Manual (Page 49)

Step 7
49
Installation Procedures
Add the reflector-mounting ring to the assembled reflector. Notice that the notches in the
mounting ring fit over the reflector seam indicating where the mounting ring should be
placed. There is also a red stripe placed on the mounting ring. This red stripe must be
aligned with the red stripe on the reflector as shown in Figure 3-34a. When all bolts are
inserted, tighten in a clockwise sequence, tabs on the mounting ring must be flush with
the reflector as shown in Figure 3-34b.
Figure 3-34a: Mounting Ring Placement
Figure 3-34b: Mounting Ring Placement