Andrew 3.7-Meter Earth Station Antenna - Manual (Page 68)

Subreflector
Adjustment
Step 1
Step 2
Step 3
Step 4
Step 5
68
Installation Procedures
After the subreflector assembly has been attached to the reflector, the subreflector must
be adjusted to ensure correct alignment. The following steps provide the procedure for
adjusting the subreflector.
Position the supplied setting bar (P/N 203896 Ku-band, P/N 203896-3 C-band) ) on the
outer edge of the subreflector as well as on the outer edge of the front ring (P/N
202790) at the twelve o’clock (top) position.
Sweep the bar across the corresponding subreflector edge, and note the relative posi-
tion.
Repeat this procedure at the six o’clock (bottom) position.
Use the noted position to indicate the required directional movement of the top portion
of the subreflector aperture, which is relative to the aperture bottom using the subreflec-
tor stud-adjustment hardware (3 places) as shown in Figure 3-55.
Figure 3-55: Subreflector Alignment
Repeat Steps 1-4 at the three o’clock and the nine o’clock positions to indicate the prop-
er aperture side adjustment.