Andrew 3.7-Meter Earth Station Antenna User Manual
Page 70
Step 9
Step 10
Step 11
Feed System
70
Installation Procedures
Obtain the corresponding measurements from the remaining subreflector struts, and
adjust the subreflector mounting hardware (4 places) to achieve a maximum differential
of 1/16 inch.
Repeat the adjustment procedure performed in Steps 1-4, until all areas of the subre-
flector are uniform.
Adjust the jam nuts, and securely tighten the adjustment hardware.
Figure 3-57: Subreflector Alignment
You have now completed the subreflector assembly. By now, you can see that your
installation of the 3.7-Meter Earth Station Antenna is almost complete. The feed system
is the last phase of the base installation. NOTE: All antenna options (such as feed sys-
tems, motors, anti-icing, etc) possess installation instructions within the individual kits
contained in the shipment.
46.925”
47.2”