Canon imagePROGRAF iPF6400S - Manual (Page 109)

iPF6400S Basic Guide
109
Tro
ubl
esho
otin
g
P
rob
lem
s Reg
ard
ing Pap
er
Roll paper cannot be inserted into the paper feed slot
Cause Corrective Action
The roll paper is warped. Straighten out curls and reload the roll.
Paper is jammed by the paper feed slot. Remove the jammed paper.
(See "Clearing Jammed Roll Paper.")➔P.102
(See "Clearing a Jammed Sheet, Fed Manually.")➔P.105
After a roll was advanced, the paper was manually pulled
out by force, closing the Paper Feed Slot. Remove the roll and open the paper feed slot.
(See "Removing the Roll from the Printer.")➔P.17
Cannot load sheets
Cause Corrective Action
The paper source selection is incorrect. Press the Load button and select the paper source.
Paper is not cut neatly
Cause Corrective Action
The paper is bent or curled at the cut
position. Straighten out any curling by the edges of the paper.
Paper rises by the ends of the cut
position before it is cut. Reload the paper correctly.
You are using paper that cannot be cut
with the Cutter Unit. Specify Manual in Cutting Mode in the Control Panel menu and use scissors
or a cutting tool to cut the roll after printing.
(See "Specifying the Cutting Method for Rolls.")➔User's Guide
Cut Speed is not configured correctly in
the Control Panel menu. Change the Cut Speed setting in the Control Panel menu.
(See "Menu Structure.")➔P.66
During cutting, printed documents fall
out at an angle. In the Control Panel menu, set Cutting Mode to Eject. Hold documents after
printing, as they are cut.
(See "Specifying the Cutting Method for Rolls.")➔User's Guide
Paper is not cut
Cause Corrective Action
The printed document became caught on a foreign object
by the Output Tray, which lifted the document. The Cutter
passed under the paper. Remove the foreign object by the Output Tray to enable the
printer to eject the printed document, keeping it level.
In the printer driver, No or Print Cut Guideline is specified
in Automatic Cutting. Specify Yes in Automatic Cutting in the printer driver.
In the Control Panel menu, Cutting Mode is set to Eject or
Manual. If the Cutting Mode is Eject, press the Cut button to cut
the paper.
If the Cutting Mode is Manual, cut rolls with scissors or the
like.
Depression on the leading edge is left
Cause Corrective Action
Keeping a roll in the printer for a long time When printing quality is most important, we recommend setting