Canon imagePROGRAF iPF6400S - Manual (Page 159)

iPF6400S Basic Guide
159
Er
ror M
essa
ge
Other
Mes
sages
Other Messages
GARO Wxxxx (x represents a number) ........................................................................................................ 159
ERROR Exxx-xxxx (x represents a letter or number) ................................................................................... 159
Hardware error. xxxxxxxx-xxxx (x represents a letter or number) ................................................................ 159
Prepare for parts replacement. ..................................................................................................................... 160
Parts replacement time has passed. ............................................................................................................ 160
Unknown file. ................................................................................................................................................ 160
Calibration There is a problem with the multi-sensor. ................................................................................... 160
Multi-sensor error ......................................................................................................................................... 160
Roll feed unit error. ....................................................................................................................................... 140
No Roll Unit. ................................................................................................................................................. 140
GARO Wxxxx (x represents a number)
Cause Corrective Action
There is a problem with the print job. Try printing again, using the correct printer driver.
It is also possible to continue printing in this state.
However, you may not be able to obtain the desired printing
results.
ERROR Exxx-xxxx (x represents a letter or number)
Cause Corrective Action
An error requiring service may have occurred. Write down the error code and message, turn off the printer,
and contact your Canon dealer for assistance.
Hardware error. xxxxxxxx-xxxx (x represents a letter or number)
Cause Corrective Action
The last portion of roll paper was used during a print job.
The paper was not advanced because the trailing edge is
taped to the roll. Turn off the printer and remove the roll from the printer
before restoring power.
Fastening tape or the Belt Stopper has not been removed
inside the Top Cover. Turn off the printer, open the Top Cover and remove the
tape or the Belt Stopper before restoring power.
An error requiring service may have occurred. Turn off the printer and wait at least three seconds before
restoring the power.
If the message is displayed again, write down the error
code and message, turn off the printer, and contact your
Canon dealer for assistance.