LG 42LD6DDH - Manual (Page 103)

8 206-4190
SAP
Analog Mode: Selects MTS sound (Mono,
Stereo, or SAP). DTV Mode: Changes the audio
language, if additional languages are available. *
INFO
Displays channel information. INFO feature is not
functional for Aux sources.
CC
Press to activate subtitles, unless the Channel
Banks Setup Menu is currently on the screen, in
which case this option displays the Lock (V-Chip)
Menu.
NUMBER Buttons (0 - 9) & DASH
Use to enter a program number or channel. Dash
is used for sub-channel numbers such as 9-1,
9-2, etc.
FLASHBK (Flashback)
Returns to the previously tuned channel.
Up/Down/Left/Right Arrows
Use to navigate on-screen menus and adjust TV
settings to your requirements.
TIMER
Sets the amount of time before the TV
automatically turns itself Off.
MENU
Displays the TV setup menus on the screen.
Also exits the on-screen menu system and
returns to TV viewing.
ALARM
Enables users to schedule a one-time “alarm”
event, in which the TV turns itself On at the
user-specified time.
MUTE POWER
BANK GUIDE
CH
PREVIEW
SAP INFO CC
OK
VOL
CH
CH
VOL
FLASHBK
TIMER ALARM MENU
ADJ
ADJ ADJ ADJ
BED1 BED2
An LG Installer Remote similar to that shown below is required to set up and operate the TV. The LG Installer
Remote illustrated below and throughout this document shows typical remote control functions and is provided
for reference only. This Installer Remote may vary from the Installer Remote supplied with the TV.
Installer Remote Control Typical Key Functions
POWER
Turns the TV On or Off.
BANK
Selects Channel Bank 1, 2, 3, or 4.
CH PREVIEW
Displays and exits the Channel Banks Setup Menu.
GUIDE
Displays and removes the electronic program
guide.
CHANNEL UP/DOWN
Selects available channels found with Auto Tuning.
VOLUME UP/DOWN
Increases/decreases sound level.
OK (Enter)
Use to direct tune channels and also to adjust TV
settings.
MUTE
Switches sound On or Off.
SAP notes:
• SAP settings are retained with power Off/On for
individual analog channels.
• If SAP is selected and no SAP is provided, sound
may not be heard on channel.
• Each analog channel may have its own SAP setting.
• Digital channels will reset to default audio language
with a power Off/On.
*
Bed Switch
Set to Bed 1 or Bed 2 as applicable (per
Installer Menu item 027 HOSPITAL MODE
setting).