Clone programmer cloning procedures (cont.) – LG 42LD6DDH User Manual

Page 126

Advertising

206-4190

Clone Programmer Cloning Procedures (Cont.)

Learning / Teaching a Master TV Setup using a TLL-1100A Clone Programmer (Cont.)

(Optional) Set the Clock
Set the time on a Master TV’s clock. (If the time has already been copied

from a TV into the TLL-1100A clone programmer, you can set the Master

TV’s clock by copying the time from the clone programmer.) The TLL-1100A

can copy the current time to both a Master TV and to the clone’s internal

clock—accurate to within one minute.
Since the TLL-1100A’s time cannot be set directly, the current time needs to

be copied from an LG TV equipped with an enabled MPI port.
After the time is copied to the TLL-1100A clone programmer, the current

time will be maintained and can then be transferred to another TV. (This can

be a Master TV or another TV which has already had the features set up.)

Teach Master TV Setup to Target TV
1. On the Target TV, if necessary exit the Express Script Installer Menu

Wizard, and then use the Installer Remote to enter the Target TV Installer

Menu: Press

MENU repeatedly until the on-screen display of the TV

setup menus no longer toggles, and then press

9-8-7-6 + OK (Enter).

2. Set Installer Menu item

117 FACT DEFAULT to 001, and press OK

(Enter). When the value changes back to 0, press OK (Enter) again to

exit the Installer Menu.

3. Tune/set the TV to an analog channel or Aux input (ideally the same

source tuned for 2-5-5 + MENU Mode during the Custom Master TV

Setup procedure, if applicable), and then connect the MPI cable to the

MPI port on the Target TV. The Clone Selection Menu will display on the

TV screen.

4. Ensure the correct Memory CBank(X) is selected on the TLL-1100A.
5. Press

2 on the Installer Remote to select TEACH TO TV from the Clone

Selection Menu. Then, press

OK (Enter) to transfer the Master TV Setup

to the Target TV.

Teaching usually takes 3 to 4 minutes. “TEACHING IN PROGRESS” will

be displayed on the screen during Teaching. When the Teaching process

is complete, a “TEACHING COMPLETE” message will be displayed.

6. When Teaching is done, disconnect the MPI cable from the Target TV,

turn OFF the TV, and unplug the TV power cord for 15 seconds.

7. Reconnect the TV power cord, and turn ON the TV. The Master TV Setup

should be resident on the Target TV.

CLONE SELECTION MENU

Selected Bank: CBankX Saved

(1) LEARN FROM TV

(2) TEACH TO TV

(3) SET CLONE CLOCK FROM TV

(4) SET TV CLOCK FROM CLONE

(5) DISPLAY TV SETUP

(6) DISPLAY CLONE SETUP

CLONE CLOCK = XX:XX

TV CLOCK = XX:XX

THE CLONE IS VERSION VX.X.X

To change menu items, press

channel keys or digits.

To execute item, press Enter.