LG 42LD6DDH - Manual (Page 139)

44 206-4190
Reference: MPI Card Slot
MP I
ANTENNA IN
RF CABLE
RF cable needs to be
disconnected to remove
current card, if applicable.
The MPI card slot is equipped with an RF jack for antenna/cable signal source connection. The slot is
also available for installing a PPV card.
Note: Turn the TV ON. If the Express Script Installer Menu Wizard is present on the display
(e.g., this is the first time the TV has been turned ON), exit the Express Script before
inserting the PPV card.
MPI Card Removal / PPV Card Installation
1. Remove the two MPI card slot retainer screws.
2. If applicable, pull out the current MPI card far enough so that the RF cable can be detached from the
old card.
3. Detach the RF cable.
4. Place the new PPV card into the slot and slide it in far enough to reconnect the RF cable.
5. Reconnect the RF cable.
6. Insert the card all the way into the slot making sure it is fully seated into the back plane connector.
7. Replace the two card slot retainer screws.
MPI CARD
SLOT
Note: On LD6DDH, MPI port is located
on TV rear jack panel (see page 41).