LG 42LD6DDH - Manual (Page 118)

23 206-4190
CHANNEL PREVIEW - BANK 1
CH 011-001 NORMAL-ADDED
Enter -> Change
CC -> VCHIP Menu, Ch. Preview -> Exit
Channel Banks Setup
Channel Banks Overview
Channel Banks enable institution administrators to create tiered channel programming on patient in-room
TVs. Each channel bank may offer a custom channel lineup for a pre-determined fee. The top tier
generally contains the most programming (premium, etc.), 2nd tier = lesser programming, 3rd tier = basic
programming, etc. It is also possible to create an Inactive TV display on one channel bank, so that an
“Inactive TV Call Attendant” message appears when the TV is turned ON. In this case, an administrator
can then select a channel bank on the patient’s in-room TV depending on the programming tier requested
by the patient.
LG3DDH and LD6DDH TVs are configured with four channel banks, i.e., Channel Banks 1, 2, 3, and 4.
All channels found during Auto Tuning automatically will be “ADDED” to all four channel banks, and the
default is for all channels to be active (NORMAL) in Channel Banks 1, 2, 3, and 4.
Note: If an FTG device is installed in a LG3DDH/LD6DDH TV and in FTG Mode, channel banks are not
supported.
Before You Begin
• Run the Express Script Installer Menu Wizard or complete the Custom Master TV Setup procedure
(see pages 9 to 10 or pages 11 to 14, respectively).
Note: Channel banks can be set up as part of the Express Script Installer Menu Wizard, if desired. The
setup options described on the following pages apply if you are setting up channel banks after completing
the Express Script Installer Menu Wizard or if you are creating a customized Master TV Setup.
• Installer Menu item 028 CH. OVERIDE must be set to 001 to allow access for channel banks setup.
Accessing the Channel Banks Setup Menu
1. To select a channel bank, press INPUT or BANK on the Installer Remote.
2. After the desired channel bank is selected, press CH PREVIEW on the Installer Remote to display the
Channel Banks Setup Menu (see below).
Typical Channel
Banks Setup Menu
Note: In the Installer Menu, all available Aux inputs are enabled by default. The Aux inputs will appear between
the highest analog and lowest digital channel number in the channel lineup when Channel Up/Down is used
on the Installer Remote. If an Aux input will not be used, it is advisable to disable it before completing the
Express Script Installer Menu Wizard or running 2-5-5 + MENU (Custom Master TV Setup). After the TV setup
is transferred to the PTC, the only way to remove Aux inputs from the channel lineup, is to go to the Channel
Banks Setup Menu and select NORMAL-DELETED. If running the Express Script, customize the Aux inputs as
appropriate in the Aux Input screen of the Installer Menu Wizard. If performing the Custom Master TV Setup
procedure, refer to Installer Menu items: 034, 035, 038, 039, 087, and (for LD6DDH only) 091.