AOC 15 - Manual (Page 171)

Appendix I-1 Recommended Tools For Installation
NOTICE: Use of the material contained in this document is subject to the warning on page Iv and the disclaimer on page v of this
document.
DOC012R02 AOC 15/50 User Manual Nov 2001
163
Tools Required For Installation
Check Qty Item USED ON
All Maintenance Tools
1 Installation Manual general
1 Electrical drawings wiring
1 Computer and program PLC control
1 Tower Directions tower assembly
1 Template tower assembly
1 Aqua-gel cable lubricant tip brake cables
1 15/16 combination wrench 5/8” blade bolts
2 15/16 socket 5/8” blade bolts
2 ½ drive socket wrench 5/8” blade bolts
1 250 in-lb torque wrench, ½ ” drive 5/8” blade bolts (120, 180 in-lb step)
6 1” Non-locking nuts temporary tower fastener
1 Crow bar tower top aligning
1 36" drift pin tower top aligning
2 1" Drift Pin tower top aligning
1 1 ½ socket, 3/4 drive 1’’ tower top bolts
1 1 ½ combination wrench 1’’ tower top bolts
1 1 7/16 socket 1’’ tower top bolts
1 600 lb torque wrench, ¾ drive 1” tower top bolts (600 ft-lbs)
1 1/2 to 3/4 drive adaptor general
1 ¾ drive socket wrench 1” tower top bolts
1 Level leveling tower
1 2 3/8 open ended wrench 1 1/2 tower base bolts
1 1 1/16 socket, 3/4" drive 5/8” brace bolts
1 1 1/16 socket, 1/2" drive 5/8” brace bolts
1 1 1/16 combination wrench 5/8” brace bolts
1 15/16 combination wrench 5/8” brace pal nuts
1 1 5/8 socket 1” flange bolt
1 1 5/8 combination wrench 1” flange pal nuts
2 + Lifting straps tower assembly, blade assembly
2 Ropes, 100 ft. maneuver turbine when raising
1 Loctite 271 blade bolts
1 7/8" socket, 1/2" drive safety cable big u-bolt
1 3/4" socket, 1/2" drive safety cable small u-bolt
1 13/16" combination safety cable pal nut
1 5/16 Allen wrench generator jct box ground lug
1 3/16 Allen wrench generator jct box connector lug
1 Rotating File removing blade epoxy
1 Grinder bit and extension removing blade epoxy
1 wire clippers anemometer zip ties
1 9/16" combination wrench anemometer bolt
1 Rubber insulation tape general
1 Wire Cutters (large wire) power wiring